Hello. I am in the process of building a conversion. I am needing some info on the proper way to secure the aluminum roof. I have steel square tube roof bows, with plywood screwed down to them. I dont know the proper method to stretch and glue(?) the aluminum continuous roof. Is there a type of glue that would glue it to the plywood? I will be using a 3" angle trim on the sides once the roof is in place. Thanks for any help.

Depending on the thickness of the aluminum you're using, and what all you're going to have on the roof (air-conditioners, tv antenna, roof vents, etc,... you may not need to worry about glue.
I used .030", have 2 roof airs' 3 vents, amp tv antenna, 4 solar panels, etc,...so it's pretty well fastened out in the middle.
If you do want it fastened down,...counter-top contact cement should hold just fine.

make sure the aluminum and the steel [screws or rivets]do not touch....they need a barrier between them....geofkaye

Thanks for the help. Is there a distributor of .030 102" wide continuous aluminum with no seams? All I have found is .040. Thanks again for your help

...what part of the country are you in....I have access but shipping is a heart attack....geofkaye

North Florida. I found the .040 at my local Great Dane semi trailer dealer/service center. I can by it reasonable and just pick it up. I guess I can give the thicker al. a try. Thanks for the help.